HotBrick Network Solutions
Load Balance
This screen is only operational if using Internet connections on both WAN ports.
Figure 10: Load Balance
These settings are only functional if using both WAN ports. If using both WAN ports, these settings determine the proportion of traffic sent over each port.
Settings – Load Balance
Load Balance Configuration
•Enable – Use this to enable your Load Balance settings. Unless this is checked, the other settings on this screen have no effect.
•Balance Type – Select the desired option:
•Bytes rx+tx – Traffic is measured by Bytes.
•Packets rx+tx – Traffic is measured by Packets.
•Sessions established – Traffic is measured by Sessions.
•Loading Share on WAN 1 – Enter the percentage (%) of traffic to be sent over WAN 1. If one WAN port connection has greater bandwidth than the other, the one with the greater bandwidth should be given a higher percentage of traffic than the other.
Click the "Update" button to save your changes.
21
