1.Detach the TouchScreen board (1) from the display panel assembly. (The TouchScreen board is attached to the display panel assembly with double-sided adhesive.)

2.Release the ZIF connector (2) to which the transfer board cable is attached, and then disconnect the transfer board cable from the system board.

3.Detach the transfer board cable (3) from the display panel assembly. (The transfer board cable is attached to the display panel assembly with double-sided adhesive.)

4.Remove the three Phillips PM2.0×4.1 screws (4) that secure the transfer board to the display panel assembly.

5.Remove the transfer board (5).

6.Remove the transfer board and cable. Reverse this procedure to install the transfer board.

32 Chapter 5 Removal and replacement procedures

Page 38
Image 38
HP 10 EE G1 Healthcare manual Removal and replacement procedures