To clean the area around the ink nozzles
1.Turn on the HP
2.Wait until the print carriage is idle and silent, and then unplug the power cord from the back of the HP
3.Lightly press down on the print cartridge to release it, and then pull it toward you out of the slot.
Note Do not remove both print cartridges at the same time. Remove and clean each print cartridge one at a time. Do not leave a print cartridge outside the HP
4.Place the print cartridge on a piece of paper with the ink nozzles facing up.
5.Lightly moisten a clean foam rubber swab with distilled water.
6.Clean the face and edges around the ink nozzle area with the swab, as shown below.
1Nozzle plate (do not clean)
2Face and edges around the ink nozzle area
Warning Do not clean the nozzle plate.
7.Allow the ink nozzle area to dry for approximately ten minutes.
8.Slide the print cartridge back into the slot. Push the print cartridge forward until it clicks into place.
9.Repeat if necessary for the other print cartridge.
10.Gently close the
Change the device settings
You can change the scroll speed and prompt delay time settings on your HP
The Scroll Speed option lets you control the rate that text messages scroll in the control panel display. For example, if the message is "Load paper, then press OK.",
User Guide | 87 |