Installation

Installation Summary

Installation Summary

This chapter describes the installation procedures for the router module. The following is a summary of those procedures:

1.Check the Version of the SNMP Module. The HP AdvanceStack 10Base-T Hub in which the HP Router 210 Module is to be installed must also have an HP J2603B Ethernet SNMP Module installed. (The router module will be mounted on the SNMP module.) This SNMP module must be the HP J2603B version, not the HP J2603A version. If an SNMP module is already installed but you are not sure which version it is, you can determine the version using the procedure beginning on page 1-5.

2.Prepare the Network. Create or update the network plan and the network map (for details, refer to page 1-8). Verify that the network equipment and links (in particular, the WAN-link-terminating equipment) are operational. (Your WAN-link service provider can verify that the WAN link is operating correctly.) If the LAN links are not already connected to the hub, connect them now (refer to the hub’s installation guide).

3.Install the Router Module.

a.Disconnect the hub from the power source, then remove the cover plate from the hub’s Expansion Slot.

b.Connect a grounding wrist strap between your wrist and the hub.

c.Remove the module from its packaging, and place it on a noncon- ducting antistatic surface.

d.Remove the insulating paper between the battery and the battery clip.

e.Remove the SNMP module from the Expansion Slot (if already installed).

1-2