Installation

1.Check the Version of the SNMP Module.

2.Look at the exposed edge of the SNMP module.

∙If an LED is mounted near the button switch, the installed SNMP module is the HP J2603B version; you can proceed with installing the router module.

∙If there is no LED there, the module is the HP J2603A version; contact your HP dealer for information about obtaining the HP J2603B version.

Button switch

If this LED is present, the SNMP module is the proper version

Figure 1-2. Checking SNMP Module

3.If you will not be installing the router module now, reinstall the cover plate:

a.Insert the tabs on the bottom of the cover plate in the small slots in the bottom of the Expansion Slot.

b.Close the cover plate, then tighten the two captured screws using a Torx T-10 or flat-blade screwdriver. Be careful not to overtighten them.

1-6