| Installation |
| 3. Install the Router Module. |
| 10. Align the edges of the SNMP module in the small slots near the |
| bottom of the Expansion Slot, then push the assembled modules |
| fully into the |
| firmly engage its mating connector within the Expansion Slot. |
|
|
C a u t i o n | For proper hub cooling, make sure you install the cover plate (as |
| described in the next two steps) after the modules are installed. |
11.Install the new cover plate provided with the router module over the Expansion Slot:
a.Insert the tabs on the bottom of the cover plate in the small slots in the bottom of the Expansion Slot.
b.Close the cover plate, then tighten the two captured screws using a Torx
Tighten two screws
Install two hex nut screws
Figure
12.Install the two hex nut screws supplied with the router module into the holes alongside the WAN port connector, then tighten them using the supplied nutdriver. Be careful not to overtighten them.
Installation 1