Installation
4. Connect the WAN Cable.
| 4. Connect the WAN Cable. |
| Connect the WAN cable as described below. |
| Also, if you have not already done so, verify that the network equipment |
| and links (in particular, the |
| tional. (Your |
| operating correctly.) If the LAN links are not already connected to the |
| hub, connect them now (refer to the hub’s installation guide). |
|
|
C a u t i o n | Static discharge may damage equipment. Do not touch the connector |
| pins on the router module or on the cable. |
| 1. Attach the cable’s |
| the connector’s screws into the hex nuts you installed alongside the |
| WAN port connector. |
Circuit from WAN service provider
WAN port
DSU/CSU stub cable | V.35 cable |
Figure
2.Attach the other end of the cable to the