Installation

1. Check the Version of the SNMP Module.

Using HP Stack Manager

1.Connect the serial port of a PC to the hub’s RS-232 Distributed Management port. (For details, refer to the hub’s installation guide.)

2.Start HP Stack Manager. (For information about installing and start- ing HP Stack Manager, refer to the hub’s installation guide. For spe- cific information about using HP Stack Manager, refer to its online help.)

3.Click on the Connect button.

After a few seconds, a list of the connected hubs appears in the Device Chain List window. You can identify a particular hub by its entry in the Station Address column. For hubs in which an SNMP module has been installed, “SNMP” appears in the Exp Slot column.

4.In the Device Chain List, either double-click on the hub into which the router module is to be installed, or select the hub and click on the Access button.

HP Stack Manager displays a graphical representation of the front of the hub (the “Hub Panel Graphic”).

5.Click on the Identify icon button.

HP Stack Manager displays information about the hub and the installed SNMP module, which is referred to in the list as “SNMP Agent”.

6.Check the value for “SNMP Agent H/W Version”. If it begins with “B” (for example: B.01.00), the installed SNMP module is the

HP J2603B version; you can proceed with installing the router mod- ule. If the value begins with “A”, the module is the HP J2603A ver- sion; contact your HP dealer for information about obtaining the HP J2603B version.

Installation 1

1-7