Installation

3. Install the Router Module.

6.Position the SNMP module, component-side down, above the router module as shown below.

Before mating the modules, make sure that the four standoffs mounted on the router module are aligned with the inner of the two holes in each corner of the SNMP module. This is the hole closest to the center of the module, not the hole closest to the corner.

Installation 1

Figure 1-6. Positioning SNMP Module Over Router Module

7.Lower the router module onto the SNMP module, then carefully press down on the circuit side of the SNMP module, alongside the connector mounting pins, until the SNMP module is flush with the tops of the standoffs.

Press here

Figure 1-7. Engaging Module Connectors

1-13