Installation
Installation Summary
f.Place the SNMP module,
g.Press the two connectors together, then insert and tighten the supplied screws through the holes in the SNMP module into the standoffs mounted on the router module.
h.Install the assembled router and SNMP modules, with the SNMP module below, into the hub’s Expansion Slot
i.Install the new cover plate provided with the router module over the Expansion Slot.
j.Install the two hex nut screws supplied with the router module into the holes alongside the WAN port connector, then tighten them using the supplied nutdriver.
For details about this procedure (including illustrations), refer to page
4.Connect the WAN Cable. For details, refer to page
5.Connect a Console. If the router is to be configured, verified, and/or managed from a PC running HP Stack Manager, connect the serial port of the PC to the hub’s
6.Verify the Router Module Starts Up Properly.
a.Connect the hub to the power source.
b.Check that the Router
c.In HP Stack Manager, click on the Connect button.
d.Highlight the hub in the Device Chain List, then press and hold down the Shift key while you click on the Access button.
e.Check that the Copyright and Main Menu screens appear.
For details about this procedure, refer to page
Installation 1