HP ProCurve 2520 TFTP: Copying a Configuration File to a Remote Host, Transferring Startup-ConfigFiles To or From a Remote Server, test­

					Switch Memory and Configuration
					Multiple Configuration Files
ProCurve(config)#				show config files
					Pressing Clear + Reset:
Configuration files:
					– Replaces all startup-config files with a single
id act pri sec				name	file named config1 that contains the default
					primary flash.
---+				+------------------------------------------------	configuration for the software version in
			– Resets the Active, Primary, and Secondary
1	*	*	*	config1	assignments as shown here.
2
3

Figure 6-20. Example of Clear + Reset ResultTransferring Startup-Config Files To or From a Remote Server

Command	Page
copy config < src-file> tftp < ip-addr> < remote-file> < pc unix >	below
copy tftp config < dest-file> < ip-addr> < remote-file> < pc unix >	below
copy config < src-file> xmodem < pc unix >	6-36
copy xmodem config < dest-file> < pc unix >	6-37

TFTP: Copying a Configuration File to a Remote Host

Syntax: copy config < src-file> tftp < ip-addr> < remote-file> < pc unix >

This is an addition to the copy tftp command options. Use this command to upload a configuration file from the switch to a TFTP server.

For more on using TFTP to copy a file to a remote server, refer to “TFTP: Copying a Configuration File to a Remote Host” on page A-24.

For example, the following command copies a startup-config file named test­

01 from the switch to a (UNIX) TFTP server at IP address 10.10.28.14:

ProCurve(config)# copy config test-01 tftp 10.10.28.14 test-01.txt unix

6-35