HP ProCurve 2520 Viewing Port Status and Configuration, brief:, config:, show interfaces brief, show interfaces config

Port Status and Configuration

Viewing Port Status and Configuring Port Parameters

broadcast-limit	page 10-19
auto-mdix	page 10-19

Viewing Port Status and Configuration

Use the following commands to display port status and configuration data.

Syntax: show interfaces [ brief config < port-list>]

brief: Lists the current operating status for all ports on the switch.

config: Lists a subset of configuration data for all ports on the switch; that is, for each port, the display shows whether the port is enabled, the operating mode, and whether it is configured for flow control.

<port-list>: Shows a summary of network traffic handled by the specified ports.

An example of the show interfaces brief command is shown below.

ProCurve(config)# show			interfaces brief
Status and Counters -			Port Status
Port	Type	Intrusion		Enabled	Status	Mode	MDI	Flow	Bcast
		Alert					Mode	Ctrl	Limit
-----	--------- +	---------		-------	------	----------	-----	-----	------
1	10/100TX	No		Yes	Up	100FDx	MDI	off	0
2	10/100TX	No		Yes	Down	10FDx	MDIX	off	0
3	10/100TX	No		Yes	Down	10FDx	MDI	off	0
4	10/100TX	No		Yes	Down	10FDx	MDIX	off	0
5	10/100TX	No		Yes	Down	10FDx	MDIX	off	0
6	10/100TX	No		Yes	Down	10FDx	MDIX	off	0

Figure 10-3. Example of show interfaces brief Command Listing

Use the show interfaces config command to view the port settings, as shown below.

10-9