HP ProCurve 2520 Trk, Trk2, Passive, Configuring a Static Trunk or Static LACP Trunk Group

Port Trunking

CLI: Viewing and Configuring Port Trunk Groups

	Configuring a Static Trunk or Static LACP Trunk Group.
	Syntax: trunk < port-list> < trk1 ... trk24 > < trunk lacp >
	Configures the specified static trunk type.
	This example uses ports C4 - C6 to create a non-protocol static trunk group
	with the group name of Trk2.
	ProCurve(config)# trunk c4-c6 trk2 trunk
	Removing Ports from a Static Trunk Group. This command removes
	one or more ports from an existing Trkx trunk group.
C a u t i o n	Removing a port from a trunk can create a loop and cause a broadcast storm.
	When you remove a port from a trunk where spanning tree is not in use,
	ProCurve recommends that you first disable the port or disconnect the link
	on that port.
	Syntax: no trunk < port-list >
	Removes the specified ports from an existing trunk group.
	For example, to remove ports C4 and C5 from an existing trunk group.
	ProCurve(config)# no trunk c4-c5
	Enabling a Dynamic LACP Trunk Group. In the default port configura­
	tion, all ports on the switch are set to disabled. To enable the switch to
	automatically form a trunk group that is dynamic on both ends of the link, the
	ports on one end of a set of links must be LACP Active. The ports on the other
	end can be either LACP Active or LACP Passive. The active command enables
	the switch to automatically establish a (dynamic) LACP trunk group when the
	device on the other end of the link is configured for LACP Passive.

12-15