HP ProCurve 2520 snmpv3 user, snmpv3 user, show snmpv3 user, Figure 13-2.Adding SNMPv3 Users and Displaying SNMPv3 Configuration

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

1.Configure users in the User Table with the snmpv3 user command. To view the list of configured users, enter the show snmpv3 user command (see “Adding Users” on page 13-8).

2.Assign users to Security Groups based on their security model with the snmpv3 group command (see “Assigning Users to Groups” on page 13-10).

C a u t i o n	If you add an SNMPv3 user without authentication and/or privacy to a group
	that requires either feature, the user will not be able to access the switch.
	Ensure that you add a user with the appropriate security level to an existing
	security group.
	Adding Users. To configure an SNMPv3 user, you must first add the user
	name to the list of known users with the snmpv3 user command.

ProCurve(config)# snmpv3 user NetworkAdmin	Add user Network Admin with
	no authentication or privacy.

ProCurve(config)# snmpv3 user NetworkMgr auth md5 authpass priv privpass

Add user Network Mgr with authentication and privacy.

MD5 authentication is enabled and the password is set to ”authpass”.

Privacy is enabled and the password is set to “privpass”.

ProCurve(config)# show snmpv3 user

Status and Counters - SNMP v3 Global Configuration Information

User Name	Auth. Protocol	Privacy Protocol
initial-----------------	--------------	----------------
	MD5	CFB AES-128
NetworkAdmin	MD5	CBC-DES

Figure 13-2. Adding SNMPv3 Users and Displaying SNMPv3 Configuration

13-8