HP ProCurve 2520 SNMP Version 3 Commands, the snmpv3 restricted-access command

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

	SNMP Version 3 Commands
	SNMP version 3 (SNMPv3) adds some new commands to the CLI for
	configuring SNMPv3 functions. To enable SMNPv3 operation on the switch,
	use the snmpv3 enable command. An initial user entry will be generated with
	MD5 authentication and DES privacy.
	You may (optionally) restrict access to only SNMPv3 agents by using the
	snmpv3 only command. To restrict write-access to only SNMPv3 agents, use
	the snmpv3 restricted-access command.
C a u t i o n	Restricting access to only version 3 messages will make the community named
	“public” inaccessible to network management applications (such as auto-
	discovery, traffic monitoring, SNMP trap generation, and threshold setting)
	from operating in the switch.
	Syntax: [no] snmpv3 enable
	Enable and disable the switch for access from SNMPv3
	agents. This includes the creation of the initial user record.
	[no] snmpv3 only
	Enables or disables restrictions to access from only SNMPv3
	agents. When enabled, the switch will reject all non-SNMPv3
	messages.
	[no] snmpv3 restricted-access
	Enables or disables restrictions from all non-SNMPv3 agents
	to read only access.
	show snmpv3 enable
	Displays the operating status of SNMPv3.
	show snmpv3 only
	Displays status of message reception of non-SNMPv3
	messages.
	show snmpv3 restricted-access
	Displays status of write messages of non-SNMPv3 messages.

13-6