HP ProCurve 2520 Parameters, Web: Viewing Port Status and Configuring Port, Configuration, [Apply Settings], [Modify Selected Ports], 2.Click on [Port Configuration]

Port Status and Configuration

Viewing Port Status and Configuring Port Parameters

ProCurve(config)# show interfaces config

Per-Port MDI

Port Settings				Configuration
Port	Type	Enabled	Mode	Flow Ctrl	MDI
-------	---------	+ -------	------------	---------	----
1	100/100T	Yes	Auto	Disable	Auto
2	100/100T	Yes	Auto	Disable	MDI
3	100/100T	Yes	Auto	Disable	MDIX
4	100/100T	Yes	Auto	Disable	Auto
5	100/100T	Yes	Auto	Disable	Auto
6	100/100T	Yes	Auto	Disable	Auto

Figure 10-12. Example of Displaying the Current MDI Configuration

ProCurve(config)# show int brief

Per-Port MDI Operating Mode

Status and Counters - Port Status
		Intrusion				MDI	Flow	Bcast
Port	Type	Alert	Enabled	Status Mode		Mode	Ctrl	Limit
-------	--------- +	---------	-------	------ ----------		-----	-----	------
1	100/100T	No	Yes	Down	1000FDx	MDIX	off	0
2	100/100T	No	Yes	Down	100FDx	MDI	off	0
3	100/100T	No	Yes	Down	100FDx	MDIX	off	0
4	100/100T	No	Yes	Down	1000FDx	Auto	off	0
5	100/100T	No	Yes	Down	1000FDx	Auto	off	0
6	100/100T	No	Yes	Up	1000FDx	Auto	off	0

Figure 10-13. Example of Displaying the Current MDI Operating ModeWeb: Viewing Port Status and Configuring Port

Parameters

In the web browser interface:

1.Click on the Configuration tab.

2.Click on [Port Configuration].

3.Select the ports you want to modify and click on [Modify Selected Ports].

4.After you make the desired changes, click on [Apply Settings].

Note that the web browser interface displays an existing port trunk group. However, to configure a port trunk group, you must use the CLI or the menu interface. For more on this topic, refer to Chapter 12, “Port Trunking” .

10-22