Required Equipment

∙Probe (or similar device) for the OmniBook 300, 425, and 430 only

CAUTION: To avoid damage due to electrostatic discharge, handle the memory module by the edges only.

Removal Procedure

1.Remove the battery and ac adapter from the OmniBook.

2.Slide the memory door off (see below illustration).

Figure 6 - Removing the Memory Module

3.Perform the appropriate action for the corresponding OmniBook:

∙OmniBook 300, 425, or 430 -- Use a probe or similar device to pull on the small post located on the front edge of the memory module.

∙OmniBook 530 -- Flip out the plastic tab on the memory module and pull the module out.

Replacement Procedure

1.Insert the memory module into the slot. (It is not possible to completely insert the memory if it is upside down.)

∙OmniBook 300, 425, 430 -- the small post on the board faces the bottom surface of the OmniBook.

∙OmniBook 530 – the plastic tab on the board faces the bottom surface of the OmniBook.

2.Press in the module until it seats fully.

3.Replace the slot cover.

4.Replace the battery and press reset.

49