Display
(HP Authorized Service Providers Only)
Required Equipment
∙Appropriate ESD station
∙Torx #6 screwdriver
∙5mm Hexdriver
∙Two small flat tip screwdrivers (or similar prying devices)
∙Probe
Removal Procedure
1.Remove the battery, ac adapter, mass storage, system card (if applicable), memory module (if installed), modem (if installed), mouse, and any installed PCMCIA accessory cards.
2.Remove the four Rubber Feet and seven Screws from the bottom case (see below illustration).
Door - Battery
Screw M2x4.6mm(T6) (Qty 6)
Battery
Rubber Foot (Qty 4)
Figure 9 - Outer Bottom Case Components
54