HP AdvanceStack Router manual 79

		Y = error type
	1300h	error code displayed if fdc is not
		configured properly
	1301h	error code if board is not ready
	1302h	error code if cmos says slot is empty
		but a card is present in the slot
	1303h	error code if cmos says slot does not
		have board with readable id but can
		read board id
	1304h	error code if cmos id and board id do
		not match
	1305h	error code if incomplete configuration
		bit is set
Memory Configuration
	2000h	bad port or wrong memory board
(POST) Errors
	2001h	bad port or wrong board type
	2002h	port reports null or no SIMMs
	2003h	can't mix single and double density
		SIMM parts
	2005h	physical SIMM config. invalid 20X5h
		X = the memory bank the checking
		routine stopped at - banks are
		numbered 0, 1, 2, or 3
	2006H	bad memory controller
DMA Errors
	21XYh	DMA controller errors
		XY= 0001 bbbb = register bbbb of
		controller 01 failed write/read test
		XY= 0010 bbbb = register bbbb of
		controller 02 failed write/read test
	213Xh	DMA status register errors
		X=0 => Controller 1's status register
		failed
		X=1 => Controller 2's status register
		failed
	22XYh	DMA Page register errors
		XY= 0001 abbb = channel bbb of
		page register bad
		bit a
		0 = ISA (0xxh) register
		1 = EISA (4xxh) register
	0010h	DMA page mask
	error codes 3000-3010 were previously used

Real-Mode (0-1Mb) RAM Errors

RAM Address Line

Independence, Parity,

& IO_CHK Errors

4000h 4XYZ - the interpretation of this error code is machine dependent

error codes 5000-5FFF were previously used

6100h errors relating to the address independence test of ram

XX= xxxx bbbb = address line bbbb is bad (no. 0 to 19)

6200h errors relating to the RAM parity 620X

72