HP 8150 MFP, 8150 N, 8150 DN manual Appendix C Printer Memory and Expansion 477

Appendix C Printer Memory and Expansion 477

2Also from the Configuration Menu, choose either PCL MEMORY or PS MEMORY and change the setting to the highest value displayed. This amount will vary depending upon how much memory is installed in the printer.

3Using a software application, download all the fonts you want to use in the selected language.

4Print a configuration page (page 314). The amount of memory used by the fonts is listed next to the language. Round this figure up to the nearest 100 KB. (For example, if 475 KB are shown, 500 KB should be reserved.)

5From the Configuration Menu, set PCL MEMORY or PS MEMORY to the value determined in step 4.

6Repeat step 3. (You must download all fonts again. See the note below.)

Note	When you change the Resource Saving setting, all downloaded
	resources (such as fonts or macros) will need to be downloaded again,
	unless they are stored on an optional hard disk or flash DIMM.

Adjusting Memory Settings