Chapter 1, Getting Started
Step 2: Load and Run the CDMA/PCS BS Test Software
Step 2: Load and Run the CDMA/PCS BS Test Software
The next step is to get the CDMA/PCS BS Test Software loaded into the Test Set and running on the IBASIC controller. Locate the memory card supplied with the PCS Interface and follow the steps of figure 3 and figure 4.
1 |
Press | 2 Wait for display to |
POWER. appear (approximately 20 seconds).
3 Press PRESET. 4 Insert the System Utility Software card.
Continued on the following page
Figure 3
15
