5.Assemble the outer rails by completing the following steps:
a.As an aid in assembly, two rubber washers have been included to help keep the rear slotted portion of the outer rail flush against the rear
Figure 6. Installing the Rubber Washers
b.Insert the alignment pins attached to the outer rail front flange into the center opening in the rack.
Note For the Compaq/Rittal rack, the alignment pins will be resting on the top surfaces of the spacers.
c.Depending on the rack you are using, complete one of the following tasks:
–For an HP rack, install one M5 Torx screw in the upper hole location of the right rail. Then, install one M5 Torx screw in the lower location of the left rail. See Figure 7.
Note Do not install the upper left and lower right screws until later.
Installing the Switch | 9 |
