HP A7540-96010 manual Power supply, Serial port, Chassis LEDs, Input Power LED green

Models: A7540-96010

1 70
Download 70 pages 39.93 Kb
Page 14
Image 14

Introduction

Power supply

The power supply converts standard 110 or 230 VAC to DC voltages for the various switch circuits. Four internal fans provide cooling. The switch monitors internal air temperature, and therefore does not monitor or report fan operational status. Air flows into the switch from the bezel side and is exhausted from the port side of the switch.

To apply power to the switch, plug the power cord into the switch AC receptacle, and then into a 110 or 230 VAC power source.

Note: The power supply and fans are not field replaceable units.

Serial port

The switch is equipped with an RS-232 serial port, to access the Command Line Interface for advanced configuration tasks and maintenance purposes. (Figure 1)

The serial port connector requires a null-modem female/female DB9 cable, using the pin configuration and connection information as detailed in “Cable pin configurations” on page 64.

Chassis LEDs

The chassis LEDs (Figure 2) provide status information about switch operation.

1

2

3

1Input Power LED (green)

2Heartbeat LED (green)

3System Fault LED (amber)

Figure 2: Chassis LEDs

Input Power LED (green)

The Input Power LED indicates the voltage status at the switch logic circuitry. During normal operation, this LED illuminates to indicate that the switch logic circuitry is receiving the proper DC voltages. When the switch is in maintenance mode, this LED is extinguished.

14

HP StorageWorks 2/8q Fibre Channel Switch Installation Guide

Page 14
Image 14
HP A7540-96010 manual Power supply, Serial port, Chassis LEDs, Input Power LED green