Configuration
Configuring the HP AdvanceStack Internet Router
Configuring the Router for the First Time
6.Enter an enable secret password:
The enable secret is a
Enter enable secret: pail
The enable password is used when there is no enable secret and when using older software and some boot images.
7.Enter the enable and virtual terminal passwords:
Enter enable password: shovel
Enter virtual terminal password: vterm1
8.Press Return to accept Simple Network Management Protocol (SNMP) management, or enter no to refuse it:
Configure SNMP Network Management? [yes]: no
9.In the following example, the router is configured for AppleTalk, Internet Protocol (IP), and Internetwork Packet Exchange (IPX). Configure the appropriate protocols for your router:
Configure Vines? [no]:
Configure LAT? [no]:
Configure AppleTalk? [no]: yes
Multizone networks? [no]: yes
Configure DECnet? [no]:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Configure CLNS? [no]:
Configure bridging? [no]:
Configure IPX? [no]: yes
Configure XNS? [no]:
Configure Apollo? [no]:
10.Next, to configure the ISDN BRI port, enter the ISDN BRI switch type. The switch type appropriate for the router depends on the ISDN service provider’s equipment. Table
Enter ISDN BRI Switch Type [none]: