Troubleshooting
Inserting the HP Internet Router Module into an HP Remote 2C
Inserting the HP Internet Router Module into an HP Remote 2C
In the topology below, HP does not recommend configuring the HP Internet Router Module for bridging. Instead configure the router to route IP, IPX, and Appletalk protocols. This is because bridging forwards multicast and broadcast packets from the 100 Mbps network to the much slower T1 or ISDN lines. This will overload the WAN link with traffic. In routing mode, the Router will not forward multicast and broadcast packets off of the network.
To A 100VG Network
Back of Remote 2C
HP Internet Router Module (in either slot of the Remote 2C)
Service Note NumbersMaintenance