Configuring the HP AdvanceStack Internet Router
Configuring the Router for the First Time
2.Determine which protocols you want on the synchronous serial interface and enter the appropriate responses. In the following example, the system is configured for IP, AppleTalk, and IPX:
Configure IP on this interface? [yes]:
Configure IP unnumbered on this interface? [no]: IP address for this interface: 172.16.73.1 Number of bits in subnet field [8]:
Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0
Configure AppleTalk on this interface? [no]: yes Extended AppleTalk network? [yes]:
AppleTalk starting cable range [2]: 4
AppleTalk ending cable range [3]: 4
AppleTalk zone name [myzone]: ZZ Serial AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes IPX network number [2]: B002
3.Configure the second synchronous serial interface, for example, as follows:
Configuring interface Serial1:
Is this interface in use? [yes]: Configure IP on this interface? [yes]: Configure IP unnumbered on this interface? [no]:
IP address for this interface: 172.16.74.2 Number of bits in subnet field [8]:
Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0
Configure AppleTalk on this interface? [no]: yes AppleTalk starting cable range [3]: 5 AppleTalk ending cable range [4]: 5 AppleTalk zone name [myzone]: ZZ Serial AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes IPX network number [3]: B003
4.The configuration you entered is now displayed and you are asked if you want to use the displayed configuration. If you enter no, you will lose the configuration information you just entered and you can begin the config- uration again. If you enter yes, the configuration will be entered and saved in the startup configuration:
Use this configuration? [yes/no]: yes Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
Configuration