Configuring the HP AdvanceStack Internet Router

Verifying Network Connectivity

Verifying Network Connectivity

After you have installed and configured the router, you can use the following commands in user EXEC mode to verify network connectivity:

■telnet—Logs in to a remote node

■ping—Sends a special datagram to the destination device, then waits for a reply datagram from that device

■trace—Discovers the routes that packets take when traveling from one router to another

If there is a problem with network connectivity, refer to the section “Reading the LEDs” in chapter 4 “Troubleshooting” and check the cable connections. If there is still a problem, check the router configuration.

Getting More Information

For more information about router software configuration, refer to the Cisco IOS configuration guide and command reference publications. These publications are available from the HP web site as described on page 1-6.

Configuration

3-20