Removing the Hard Disk Drive
(User-Replaceable)
Required Equipment
•Small Phillips screwdriver.
Removal Procedure
Important
If you are installing a new hard disk drive, load the factory software and operating system on the drive as described in “Recovering the Factory Software,” as shown on the next page.
1.Unplug the AC adapter, if present, and then remove the battery.
2.On the bottom of the notebook, remove the hard drive rubber screw plugs and retaining screws.
3.Carefully pull the hard drive out of the notebook.
Screw, M2.5×6mm (2)
Figure 2-5. Removing the Hard Disk Drive
HP Omnibook XE4100/XE4500 | Removal and Replacement |
