Connecting to the Command Line Interface

Make an Ethernet cornnection and log into the 4Gb SAN Switch:

1.Connect the workstation to the Ethernet network containing the OA. If the OA is not on a network, connect directly to the OA/iLO Ethernet port on the active OA.

IMPORTANT:

Verify that the switch is not being re-configured from any other connections during the remaining steps.

2.Open a telnet connection using the IP address set earlier. The login prompt displays when the telnet connection locates the switch in the network.

3.Enter the user name, using the administrative account admin.

4.Enter the password. The default password is password.

NOTE:

Run up to two simultaneous admin sessions and four user sessions.

If you have not changed the system passwords from the default, you are prompted to change them. Enter the new system passwords, or press Ctrl-c to skip the password prompts.

5.Verify that the login was successful. If successful, the prompt displays the switch name and user ID to which you are connected.

32Setup