Changing Your Computer Hardware Configuration

System Unit Power Supply

Closing the System Unit After Propping Up the Power Supply

Once you complete the task you set out to perform, you are ready to close the system unit. To close the system unit follow these steps:

1.Pull slightly back on the power supply until you are able to remove the bail from the bail lock. Using the power supply handle lower it downward into its original operating position. See Figure 5-3.

2.Tighten both captive screws in place as seen in Figure 5-3.Use a T-15 Torx driver and 6 inch-pounds of torque to tighten the screws.

3.Replace the left side panel of the system unit as shown in the section “Closing the Left Side Panel of the System Unit” in this chapter.

Chapter 5

105