Changing Your Computer Hardware Configuration

Removable Media Devices

6.Tighten the two CD drive bracket screws as shown in Figure 5-22.These should be tightened using 6 inch-pounds of torque.

Figure 5-22 Tightening the Bracket Screws

Bracket

Bracket

Screw

Screw

7.Place the audio, ATAPI and power cables inside the CD drive bay, and position the cables so that they go under the bottom edge of the CD drive bay’s rear cover. The CD drive bay’s rear cover’s edge is rounded to keep you from cutting the cables. See Figure 5-23.Next, place the end opposite the rear cover handle into the cover slot, rotate it into place, and tighten the T-15 Torx/slotted screw using 6 inch-pounds of torque. This will secure the rear cover in place. See Figure 5-23.You have completed the removal of the CD drive.

Figure 5-23 Replacing the CD Drive Bay’s Rear Cover

Rear Cover

Rear Cover

Handle

 

Audio

T-15

Torx/Slotted

Cable

Screw

Ferrite Bead

ATAPI Cable

Power Cable

Chapter 5

125