Changing Your Computer Hardware Configuration

Removable Media Devices

5.Remove the CD drive from its shipping container and check to see that the jumper on the back of the CD drive is set to the C Select position. Using the four blank filler screws (T-10 Torx/slotted screws) that were just removed, mount the disk drive to the bracket as shown in Figure 5-14.The screws should be tightened using 6 inch-pounds of torque. Note that the CD drive should extend approximately one inch out from the front of the CD drive bracket.

Figure 5-14 Installing the CD Drive

CD Drive Bracket Guide

CD Drive

Blank Filler Screws

Bracket Screws

6.Slide the CD drive and its bracket into the system unit chassis as shown in Figure 5-14.There are runners on the side of each bracket and guides inside the CD drive chassis that will help the assembly to slide into place.

Chapter 5

117