Changing Your Computer Hardware Configuration

Removable Media Devices

7.Tighten the two floppy disk bracket screws as shown in Figure 5-35.You will need to tighten them using 6 inch-pounds of torque.

Figure 5-35 Tightening the Bracket Screws

Bracket Screw

Bracket Screw

8.Make sure that the floppy data and power cables are positioned so that they come out of the top edge of the rear floppy disk drive bay’s cover. This edge is rounded to prevent cutting of the cables. See Figure 5-36.Put the rear cover in place and tighten the T-15 Torx/slotted screw using 6 inch-pounds of torque.

Figure 5-36 Replacing the Rear Floppy Disk Drive Bay’s Cover

Rear Cover Handle

T-15

Torx/slotted

PowerScrew

Cable

Rear Cover

Data Cable

138

Chapter 5