HP NonStop NS manual Displaying SCF Configuration Information for Subsystems, TCP/IP Subsystem

Determining Your System Configuration	Displaying SCF Configuration Information for
	Subsystems

To display information about a particular device:

> SCF LISTDEV TYPE n

where n is a number for the device type. For example, if n is 3, the device type is disks. For the \MS9 system, entering LISTDEV TYPE 3 would display information for $DATA6, $DATA5, $DATA4, $DATA3, $DATA2, $DATA1, and $DATA.

To display information for a given subsystem:

> SCF LISTDEV subsysname

where subsysname is the logical name of a subsystem; for example, $ZZKRN for the Kernel subsystem.

Displaying SCF Configuration Information for Subsystems

The following tables give some of the SCF commands that display configuration information for objects controlled by subsystems that are common to most Integrity NonStop NS-series systems. The examples use the SCF ASSUME command to make a given subsystem the current default object for gathering information.

TCP/IP Subsystem

These examples are based on a TCP/IP process named $ZTCO. Before using the commands listed in Table 2-2, type this command to make the TCP/IP subsystem the default object:

> SCF ASSUME PROCESS $ZTCO

Table 2-2. Displaying Information for the TCP/IP Subsystem ($ZTCO)

To Display Information About These
Configured Objects	Enter This Command
All TCP/IP devices	LISTDEV TCPIP
Detailed information about the TCP/IP	INFO, DETAIL
subsystem manager
All SUBNET names	INFO SUBNET *
All ROUTE names	INFO ROUTE *

Integrity NonStop servers support two versions of TCP/IP—NonStop TCP/IPv6 and NonStop TCP/IP. When you use the SCF LISTDEV and INFO commands, all current TCP/IP processes are displayed. For more information, refer to the TCP/IPv6 Configuration and Management Manual and the TCP/IP Configuration and Management Manual.

HP Integrity NonStop NS-Series Operations Guide—529869-005

2-9