HP Quality Center Synchronizer 1.2 Enabling and Disabling Synchronization Links, Enabled, Disabled, Disabled, Disabled, Unvalidated, Unvalidated, Enable Link, Link > Enable

Chapter 4 • Working with Quality Center Synchronizer

Enabling and Disabling Synchronization Links

Each synchronization link can be in one of the following states: Unvalidated, Disabled, and Enabled. The following table lists these states and their descriptions. It also lists under what circumstances the link moves between states.

State	Description	When State Entered	When State Left
Unvalidated	The link’s	Upon creation of a	Upon execution of an
	configuration	new link or	integrity check. For
	has not been	modification of the	more information on
	verified. You	configuration of an	running integrity
	cannot run tasks	existing link.	checks, see “Running
	for the link.		Link Tasks Manually”
			on page 91.
Disabled	The link’s	Upon successful	Manually to status
	configuration	completion of an	Enabled, or after
	has been	integrity check, or	modification of link
	verified, but you	manually from	configuration to status
	cannot run tasks	status Enabled.	Unvalidated.
	on the link.
Enabled	The link’s	Manually from	Manually to status
	configuration	status Disabled.	Disabled, or after
	has been		modification of link
	validated, and		configuration to status
	you can run		Unvalidated.
	tasks on the
	link.

To enable a synchronization link:

1In the Links list or Links Grid, select the link you want to enable.

2Make sure that the link is in the state Disabled. If the link is in the state Unvalidated, you must run an integrity check to change its state to Disabled. For more information on running integrity checks, see “Running Link Tasks Manually” on page 91.

3 Click the Enable Link button or choose Link > Enable.

102