CENTRONICS INTERFACE BOARD
Specifying XX YY at values greater than those indicated will cause the V8.5E to terminate scans incorrectly.
3.) 1B 4X and control characters
Other commands that can be sent to the V8.5E Centronics adapter:
1B 41 | remote clear |
1B 42 | remote line terminate |
1B 43 | remote end of transmission |
1B 44 | remote form feed |
1B 45 | remote reset |
1B 50 ZZ | sends blank scans to plotter from ZZ = 01 |
| hex to FF hex |
NOTE: These commands must be sent when the plotter is in print mode. The commands will be ignored and inter- preted as raster data if they are sent at any other time.
C
The V8.5E plotter also obeys standard control characters which must be sent when the plotter is in print mode:
04 end of transmission
0A line feed
0C form feed
NOTE: print mode on the V8.5E means that all bytes that are received by the plotter are interpreted as ASCII characters and printed at 108 characters/line.
V8.5eRev2.2.2002 | |
|
