HP x2 1011 G1 manual Wlan module, 806724-005

Reverse this procedure to install the battery.

WLAN module

Description	Spare part number
Intel Tri Band Wireless-AC 17265 802.11a/b/g/n/ac 2×2 and Bluetooth 4.0 + WiGig Combo Adapter	806724-005
Intel Dual Band Wireless-AC 7265 802.11a/b/g/n/ac 2×2 WiFi and Bluetooth 4.0 Combo Adapter	756749-005
Intel Dual Band Wireless-AN 7265 802.11a/b/g/n 2×2 and Bluetooth 4.0 Combo Adapter	756748-005

CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module authorized for use in the slate by the governmental agency that regulates wireless devices in your country or region. If you replace the module and then receive a warning message, remove the module to restore device functionality, and then contact technical support.

Before removing the WLAN module, follow these steps:

1.Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the slate.

3.Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the slate.

4.Remove the display panel assembly (see Display panel assembly on page 32).

5.Disconnect the battery cable from the system board (see Battery on page 36).

Remove the WLAN module:

1.Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.

NOTE: The WLAN antenna cable labeled “1/Main” connects to the WLAN module “1/Main” terminal. The WLAN antenna cable labeled “2/Aux” connects to the WLAN module “2/Aux” terminal.

2.Remove the Phillips PM1.9×3.4 screw (2) that secures the WLAN module to the bottom cover. (The WLAN module tilts up.)

WLAN module 37