HP x2 1011 G1 manual Solid-state drive

Reverse this procedure to install the RTC battery.

Solid-state drive

Description	Spare part number
512-GB, M2, SATA-3 solid-state drive	811391-001
256-GB, M2, SATA-3	793709-001
256-GB, M2, SATA-3 solid-state drive supporting TLC	811793-001
256-GB, M2, SATA-3, SED solid-state drive supporting Opal 2	810987-001
180-GB, M2, SATA-3	811389-001
180-GB, M2, SATA-3, SED solid-state drive supporting Opal 2	811390-001
128-GB, M2, SATA-3	793708-001
128-GB, M2, SATA-3 solid-state drive supporting TLC	811392-001

Before removing the solid-state drive, follow these steps:

1.Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the slate.

3.Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the slate.

4.Remove the display panel assembly (see Display panel assembly on page 32), and then remove the following components:

a.Battery (see Battery on page 36)

b.WLAN module (see WLAN module on page 37)

c.WWAN module (see WWAN module on page 39)

d.Fan (see Fan on page 43)

e.System board (see System board on page 49)

Remove the solid-state drive:

1.Turn the system board upside down with the docking connector toward you.

2.Remove the Phillips PM1.3×1.9 screw that secures the solid-state drive to the system board. (The solid- state drive tilts up.)

Solid-state drive 57