HP x2 1011 G1 manual Restoring factory settings in Slate Setup

Select Main > Ignore Changes and Exit, and then follow the on-screen instructions.

●To save your changes and exit Slate Setup menus:

Click the Save icon in the lower-right corner of the screen, and then follow the on-screen instructions.

– or –

Select Main > Save Changes and Exit, and then follow the on-screen instructions.

Your changes go into effect when the slate restarts.

Restoring factory settings in Slate Setup

NOTE: Restoring defaults will not change the hard drive mode.

To return all settings in Slate Setup to the values that were set at the factory, follow these steps:

1.Turn on or restart the slate, and then press esc or hold down the volume button while the "Hold the Volume Down button to enter the BIOS Startup Menu" message is displayed at the bottom of the screen.

2.Press or tap f10 to enter Slate Setup.

3.Use a pointing device, the arrow keys, or touch the screen to select Main > Restore Defaults.

4.Follow the on-screen instructions.

5.To save your changes and exit, click the Save icon in the lower-right corner of the screen, and then follow the on-screen instructions.

– or –

Select Main > Save Changes and Exit, and then follow the on-screen instructions.

Your changes go into effect when the slate restarts.

NOTE: Your password settings and security settings are not changed when you restore the factory settings.

Using Slate Setup 89