Manuals / HP / Computer Equipment / Laptop

HP ZBook 14 Mobile manual Removing and replacing the access panel

Models: ZBook 14 Mobile

1 53

Page 19

3.Insert the hooks on the right side of the I/O panel (1) into the right side of the back of the chassis, and then press the left side (2) to the chassis until it locks in place.

Removing and replacing the access panel 13

Page 19

Image 19

HP ZBook 14 Mobile manual Removing and replacing the access panel

Contents

HP t620 Flexible Series Thin Client Hardware Reference GuideHardware Reference Guide About This Book iv About This Book 2 Hardware changes Table of contents1 Product features Appendix A SpecificationsAppendix E Shipping information Appendix B Removing and replacing the batteryAppendix C Thin client operation Appendix D Electrostatic dischargeStandard features 1 Product featuresFront panel components Rear panel components Num Lock key Using the keyboardCaps Lock key Scroll Lock keyWindows Logo Key Special mouse functionsAdditional function keys 6 Chapter 1 Product features Serial number locationWarnings and cautions 2 Hardware changesConnecting the power cord Attaching the stand Removing the access panel Removing and replacing the access panel5. Remove the computer from the stand Removing and replacing the access panel6. Lay the unit flat on a stable surface with the right side up To replace the access panel Replacing the access panel12 Chapter 2 Hardware changes Removing and replacing the access panel Installing internal USB flash drives Installing internal USB flash drives SODIMMs Installing additional memoryDDR3L-SDRAM SODIMMs Populating SODIMM sockets Installing SODIMMson page 18 Chapter 2 Hardware changes 8. Locate the memory compartment on the system board Installing additional memoryNOTE Be sure to retain the two screws and the springs beneath them 20 Chapter 2 Hardware changes 19. Replace the computer stand Installing additional memory22 Chapter 2 Hardware changes 20. Reconnect the power cord and turn on the computerInstalling a half-height PCI-Express 2.0 card 9. Slide the expansion slot cover left and remove it 8. Locate the slot in the riser card24 Chapter 2 Hardware changes Installing a half-height PCI-Express 2.0 card 14. Reconnect the power cord and turn on the computer13. Replace the computer stand Hood sensor Security1. Locate the cable lock slot on the back panel Cable lockSecurity Mounting the thin client Mounting the thin client 30 Chapter 2 Hardware changes Mounting the thin client Supported mounting optionsTemperature Range fanless design A Specifications32 Appendix A Specifications DimensionsRated Output Current maximum Power SupplyPower Output maximum Maximum Altitude unpressurizedB Removing and replacing the battery 2 up and out of the way b. If a PCIe card is installed, remove it carefully36 Appendix B Removing and replacing the battery 8. Locate the battery on the system board9. Carefully pry the battery up from the system board 10. Unplug the battery cable connector from the system board15. Replace the computer stand Routine thin client care C Thin client operationSupported orientations 40 Appendix C Thin client operation Non-supported orientation Preventing electrostatic damage D Electrostatic dischargeGrounding methods Removing the solid state drive flash memory Important service repair informationE Shipping information Shipping preparation44 Appendix E Shipping information 8. Remove the two screws securing the SSD to the system board9. Carefully pull the SSD out of the socket Important service repair informationK keyboard Index