Manuals / HP / Computer Equipment / Laptop

HP ZBook 14 Mobile manual Supported mounting options, Mounting the thin client

Models: ZBook 14 Mobile

1 53

Download 53 pages 32.2 Kb

Page 37

Supported mounting options

Supported mounting options

The following illustrations demonstrate some of the supported mounting options for the mounting bracket.

Mounting the thin client 31

Image 37

HP ZBook 14 Mobile manual Supported mounting options, Mounting the thin client

Contents

HP t620 Flexible Series Thin Client Hardware Reference GuideHardware Reference Guide About This Book iv About This Book 1 Product features Table of contentsAppendix A Specifications 2 Hardware changesAppendix C Thin client operation Appendix B Removing and replacing the batteryAppendix D Electrostatic discharge Appendix E Shipping informationStandard features 1 Product featuresFront panel components Rear panel components Caps Lock key Using the keyboardScroll Lock key Num Lock keyWindows Logo Key Special mouse functionsAdditional function keys 6 Chapter 1 Product features Serial number locationWarnings and cautions 2 Hardware changesConnecting the power cord Attaching the stand Removing the access panel Removing and replacing the access panel5. Remove the computer from the stand Removing and replacing the access panel6. Lay the unit flat on a stable surface with the right side up To replace the access panel Replacing the access panel12 Chapter 2 Hardware changes Removing and replacing the access panel Installing internal USB flash drives Installing internal USB flash drives SODIMMs Installing additional memoryDDR3L-SDRAM SODIMMs Populating SODIMM sockets Installing SODIMMson page 18 Chapter 2 Hardware changes 8. Locate the memory compartment on the system board Installing additional memoryNOTE Be sure to retain the two screws and the springs beneath them 20 Chapter 2 Hardware changes 19. Replace the computer stand Installing additional memory22 Chapter 2 Hardware changes 20. Reconnect the power cord and turn on the computerInstalling a half-height PCI-Express 2.0 card 9. Slide the expansion slot cover left and remove it 8. Locate the slot in the riser card24 Chapter 2 Hardware changes Installing a half-height PCI-Express 2.0 card 14. Reconnect the power cord and turn on the computer13. Replace the computer stand Hood sensor Security1. Locate the cable lock slot on the back panel Cable lockSecurity Mounting the thin client Mounting the thin client 30 Chapter 2 Hardware changes Mounting the thin client Supported mounting options32 Appendix A Specifications A SpecificationsDimensions Temperature Range fanless designPower Output maximum Power SupplyMaximum Altitude unpressurized Rated Output Current maximumB Removing and replacing the battery 2 up and out of the way b. If a PCIe card is installed, remove it carefully9. Carefully pry the battery up from the system board 8. Locate the battery on the system board10. Unplug the battery cable connector from the system board 36 Appendix B Removing and replacing the battery15. Replace the computer stand Routine thin client care C Thin client operationSupported orientations 40 Appendix C Thin client operation Non-supported orientation Preventing electrostatic damage D Electrostatic dischargeGrounding methods E Shipping information Important service repair informationShipping preparation Removing the solid state drive flash memory44 Appendix E Shipping information 8. Remove the two screws securing the SSD to the system board9. Carefully pull the SSD out of the socket Important service repair informationK keyboard Index