Manuals / HP / Computer Equipment / Laptop

HP ZBook 14 Mobile manual Supported orientations

Models: ZBook 14 Mobile

1 53

Download 53 pages 32.2 Kb

Page 45

Supported orientations

Supported orientations

HP supports the following orientations for the thin client.

CAUTION: You must adhere to HP-supported orientations to be sure that your thin client functions properly.

NOTE: HP t620 standard (slim) chassis: HP recommends mounting the thin client in the vertical (tower) orientation, with the HP logo right-side up. Mounting in other orientations may result in decreased performance under certain conditions; operating the computer with limited power to prevent overheating is one such condition.

Supported orientations 39

Image 45

HP ZBook 14 Mobile manual Supported orientations

Contents

HP t620 Flexible Series Thin Client Hardware Reference GuideHardware Reference Guide About This Book iv About This Book 1 Product features Table of contentsAppendix A Specifications 2 Hardware changesAppendix C Thin client operation Appendix B Removing and replacing the batteryAppendix D Electrostatic discharge Appendix E Shipping informationStandard features 1 Product featuresFront panel components Rear panel components Caps Lock key Using the keyboardScroll Lock key Num Lock keySpecial mouse functions Windows Logo KeyAdditional function keys 6 Chapter 1 Product features Serial number locationWarnings and cautions 2 Hardware changesConnecting the power cord Attaching the stand Removing the access panel Removing and replacing the access panelRemoving and replacing the access panel 5. Remove the computer from the stand6. Lay the unit flat on a stable surface with the right side up Replacing the access panel To replace the access panel12 Chapter 2 Hardware changes Removing and replacing the access panel Installing internal USB flash drives Installing internal USB flash drives Installing additional memory SODIMMsDDR3L-SDRAM SODIMMs Installing SODIMMs Populating SODIMM socketson page 18 Chapter 2 Hardware changes Installing additional memory 8. Locate the memory compartment on the system boardNOTE Be sure to retain the two screws and the springs beneath them 20 Chapter 2 Hardware changes 19. Replace the computer stand Installing additional memory22 Chapter 2 Hardware changes 20. Reconnect the power cord and turn on the computerInstalling a half-height PCI-Express 2.0 card 8. Locate the slot in the riser card 9. Slide the expansion slot cover left and remove it24 Chapter 2 Hardware changes 14. Reconnect the power cord and turn on the computer Installing a half-height PCI-Express 2.0 card13. Replace the computer stand Hood sensor SecurityCable lock 1. Locate the cable lock slot on the back panelSecurity Mounting the thin client Mounting the thin client 30 Chapter 2 Hardware changes Mounting the thin client Supported mounting options32 Appendix A Specifications A SpecificationsDimensions Temperature Range fanless designPower Output maximum Power SupplyMaximum Altitude unpressurized Rated Output Current maximumB Removing and replacing the battery 2 up and out of the way b. If a PCIe card is installed, remove it carefully9. Carefully pry the battery up from the system board 8. Locate the battery on the system board10. Unplug the battery cable connector from the system board 36 Appendix B Removing and replacing the battery15. Replace the computer stand Routine thin client care C Thin client operationSupported orientations 40 Appendix C Thin client operation Non-supported orientation D Electrostatic discharge Preventing electrostatic damageGrounding methods E Shipping information Important service repair informationShipping preparation Removing the solid state drive flash memory44 Appendix E Shipping information 8. Remove the two screws securing the SSD to the system board9. Carefully pull the SSD out of the socket Important service repair informationK keyboard Index