Manuals / HP / Computer Equipment / Laptop

HP ZBook 14 Mobile manual Reconnect the power cord and turn on the computer, Hardware changes

Models: ZBook 14 Mobile

1 53

Download 53 pages 32.2 Kb

Page 28

20.Reconnect the power cord and turn on the computer.

21.Lock any security devices that were disengaged when the computer cover or access panel was removed.

The computer automatically recognizes the additional memory when you turn on the computer.

22 Chapter 2 Hardware changes

Image 28

HP ZBook 14 Mobile manual Reconnect the power cord and turn on the computer, Hardware changes

Contents

Hardware Reference Guide HP t620 Flexible Series Thin ClientHardware Reference Guide About This Book iv About This Book Table of contents 1 Product featuresAppendix A Specifications 2 Hardware changesAppendix B Removing and replacing the battery Appendix C Thin client operationAppendix D Electrostatic discharge Appendix E Shipping information1 Product features Standard featuresFront panel components Rear panel components Using the keyboard Caps Lock keyScroll Lock key Num Lock keyWindows Logo Key Special mouse functionsAdditional function keys Serial number location 6 Chapter 1 Product features2 Hardware changes Warnings and cautionsConnecting the power cord Attaching the stand Removing and replacing the access panel Removing the access panel5. Remove the computer from the stand Removing and replacing the access panel6. Lay the unit flat on a stable surface with the right side up To replace the access panel Replacing the access panel12 Chapter 2 Hardware changes Removing and replacing the access panel Installing internal USB flash drives Installing internal USB flash drives SODIMMs Installing additional memoryDDR3L-SDRAM SODIMMs Populating SODIMM sockets Installing SODIMMson page 18 Chapter 2 Hardware changes 8. Locate the memory compartment on the system board Installing additional memoryNOTE Be sure to retain the two screws and the springs beneath them 20 Chapter 2 Hardware changes Installing additional memory 19. Replace the computer stand20. Reconnect the power cord and turn on the computer 22 Chapter 2 Hardware changesInstalling a half-height PCI-Express 2.0 card 9. Slide the expansion slot cover left and remove it 8. Locate the slot in the riser card24 Chapter 2 Hardware changes Installing a half-height PCI-Express 2.0 card 14. Reconnect the power cord and turn on the computer13. Replace the computer stand Security Hood sensor1. Locate the cable lock slot on the back panel Cable lockSecurity Mounting the thin client Mounting the thin client 30 Chapter 2 Hardware changes Supported mounting options Mounting the thin clientA Specifications 32 Appendix A SpecificationsDimensions Temperature Range fanless designPower Supply Power Output maximumMaximum Altitude unpressurized Rated Output Current maximumB Removing and replacing the battery b. If a PCIe card is installed, remove it carefully 2 up and out of the way8. Locate the battery on the system board 9. Carefully pry the battery up from the system board10. Unplug the battery cable connector from the system board 36 Appendix B Removing and replacing the battery15. Replace the computer stand C Thin client operation Routine thin client careSupported orientations 40 Appendix C Thin client operation Non-supported orientation Preventing electrostatic damage D Electrostatic dischargeGrounding methods Important service repair information E Shipping informationShipping preparation Removing the solid state drive flash memory8. Remove the two screws securing the SSD to the system board 44 Appendix E Shipping informationImportant service repair information 9. Carefully pull the SSD out of the socketIndex K keyboard