Humax 525p manual Performing a Code Search

C h a p t e r 6 M e s s a g e s & S e t u p

4.Enter a code. Use the number buttons on the remote control to enter a four-digit code (starting with the first code in the list on the screen). After you press the fourth digit of the code, the red light on the end of the remote control should flash. If it doesn’t, try the next code.

5.Test the code. Point the remote towards the TV and test the button:

To Test the:	TV power, volume,	TV input	A/V receiver power,	A/V receiver volume
	and mute		volume, and mute	and mute only
Press the:	TV POWER button	TV INPUT button	TV POWER button	MUTE button

If pressing the button works (e.g., turns the TV or A/V receiver off, or changes the TV input), the code is correct. If it does not work, repeat steps 3 and 4 using the next code on the list. If none of the codes works, perform a code search (see below).

Performing a Code Search

If none of the codes listed allows you to control your device, a code search may detect the correct code. Performing a code search can take up to 20 minutes.

1.Prepare the remote control. Point the remote away from your Recorder and cover the front end with your hand.

Refer to the table below and determine which two buttons to press to prepare the remote. Press and hold the buttons simultaneously for about 5 seconds (until the red light at the end of the remote lights up and stays lit when you release the buttons).

To Control:	TV power, volume,	TV input	A/V receiver power,	A/V receiver volume
	and mute		volume, and mute	and mute only
Press the:	TV POWER and	TV INPUT and	TV POWER and	MUTE and
	TiVo buttons	TiVo buttons	TiVo buttons	TiVo buttons

98 TiVo Central Messages & Setup Settings Remote Control & Recorder Front