Humax 525p manual To Test

R e m o t e C o n t r o l & R e c o r d e r F r o n t

2.Enter the search code. Refer to the table below and use the number keys on your remote control to enter the appropriate code.

To Test:	TV power, volume,	TV input	A/V receiver power,	A/V receiver volume
	and mute		volume, and mute	and mute only
Enter:	0999	0999	1999	1999

After you press the fourth digit of the code, the red light on the end of the remote control will flash twice, then remain on.

3.Test the remote control. Point the remote control at the TV or A/V receiver. Press CHAN UP to test the first code. The test is successful if the TV or A/V receiver responds (by powering off, changing input, or muting, depending on the function you

are trying to program). If there is no response, wait two or three seconds, then press

CHAN UP again. Continue doing this until the TV or A/V receiver responds. 6

When the TV or A/V receiver does respond, press ENTER to select the current code. The red light at the end of the remote control will flash three times to indicate that the remote control is properly coded to control your device.

When the red light on the end of the remote control turns off, you have reached the end of the available codes.

Unfortunately, due to the great variety of TVs and A/V receivers, some makes and models are not compatible with your Recorder’s remote control. If you reach the end of the available codes without finding a code that works with your device, you will need to use your TV or A/V receiver’s remote to turn it on and off, and control the volume.

TiVo Central Messages & Setup Settings Remote Control & Recorder Front 99