Husqvarna FS4800D Machine SET-UP, Hour Operation Check List, Service Daily, Service Yearly

Pre Operation Checklist

Before leaving our factory, every machine is thoroughly tested. Follow our instructions strictly and your machine will give you long service in normal operating conditions.

Before starting up the machine, make sure you read these entire Operating Instructions and are familiar with the operation of the machine.

MACHINE SET-UP:

ALWAYS park machine on a level surface with the engine “OFF” and the ignition switch set in the “0” (OFF) position before performing any maintenance. Let the machine cool down!!

1.Check engine oil. Fill to the full mark on dip stick with 15W40 oil.

2.Connect battery cables.

1 - 2 HOUR OPERATION CHECK LIST:

ALWAYS park machine on a level surface with the engine “OFF” and the ignition switch set in the “0” (OFF) position before performing any maintenance. Let the machine cool down!!

1.Check the engine air cleaner hose clamps. Tighten as required.

2.Tension the blade drive V-belts. DO NOT over tension!!

Scheduled Maintenance Quick Reference

Before performing any maintenance, ALWAYS park the machine on a level surface with the engine “OFF” and the ignition switch set in the “OFF” position. Let the machine cool down!!

SERVICE DAILY:

1.Check engine oil level.

2.Check blade guard for damage.

3.Check hoses and clamps for damage or looseness. Tighten or replace as necessary.

4.Check air cleaner AIR RESTRICTION INDICATOR

(1N). Replace primary air filter if indicator is red.

5.Make sure all safety guards are in place and in good condition.

6.Drain Water from ENGINE GEARBOX (3-1A, 3-2A) using WATER DRAIN VALVE (3-1C, 3-2C).

SERVICE EVERY 50 HOURS:

1.Inspect Radiator Air Filter and clean as necessary.

2.Check blade drive V-belt tension. Tension both sides evenly. DO NOT over tension!!!

3.Lubricate front wheel bearings.

4.Replace Hydraulic System Filter. (First 50 hours only.)

SERVICE EVERY 100 HOURS:

1.Replace engine oil and filter.

2.Lubricate front axle pivot bearings.

3.Check wheels for wear or damage.

4.Check rear wheel hubs and wheels for looseness.

5.Check engine air cleaner hose and clamps.

6.Check hydraulic system fluid level.

SERVICE EVERY 250 HOURS:

1.Replace Hydraulic System Filter

2.Grease Blade Shaft 2 pumps each end.

SERVICE EVERY 500 HOURS:

1.Replace Engine gearbox fluid.

2.Replace hydraulic system fluid.

3.Replace engine fuel filter (spin-on type).

SERVICE YEARLY:

1. Replace air filter primary and safety element.

44