Husqvarna FS4800D manuel dutilisation 1M. V-BELTS Set of 4, 3 Groove, 1N. Gearbox Pulley

2L. BLADE GUARD SPADE LATCH: Used to hold the blade guard in position. To remove the blade guard, use the WIRE LANYARD (2K) to pivot the inner BLADE GUARD SPADE LATCH to the open position, and then lift the blade guard up and off of the machine.

2M. REAR BOLT: Retains Blade Guard In position (except 36” and 900mm). REAR BOLT must be removed before removing BLADE GUARD. Always install REAR BOLT in blade guard before operating machine.

FIGURE 3-1

3-1A. ENGINE GEARBOX: Single Speed Model.

3-1B. WATER CONNECTION: Circulates freshwater through gearbox to cool it. Water then flows to the bladeguard.

3-1C. WATER DRAIN VALVE: To drain water from gear- box: Turn Counterclockwise to open, Clockwise to close. Drain daily to prevent corrosion or damage due to freezing temperatures.

3-1D. HOOD LATCH: Two latches, located on the front frame of the machine secure the ENGINE HOOD (6E) in the lowered position. Rotate each latch 180 degrees, Counter-Clockwise, and the ENGINE HOOD (6E) can be lifted. For European CE models, the latch is a slotted design, and a tool, such as a screw driver must be used to open the latch.

3-1E. FLANGE COVER: Guards against FLANGE con-

tact during operation. Always keep in place!

3-1F. BELT PROTECTOR SHIELD: Keep in place.

3-1G. BLADESHAFT TUBE ASSY: Sealed unit contains bladeshaft, bearings and shaft seals.

3-1H. TIEDOWN LUGS: Used to tie the saw down while transporting by vehicle. Not to be used to lift the saw.

3-1I. ENGINE OIL DRAIN VALVE: Drains engine oil without use of tools.

3-1J. BELT TENSIONING BOLTS:

3-1K. HORIZONTAL CLAMPING BOLTS:

3-1L. BLADE SHAFT PULLEY:

3-1M. V-BELTS: Set of 4, 3 Groove

3-1N. GEARBOX PULLEY:

FIGURE 3-2

3-2A. ENGINE GEARBOX: Three Speed Model.

3-2B. WATER CONNECTION: Circulates freshwater through gearbox to cool it. Water then flows to the bladeguard.

3-2C. WATER DRAIN VALVE: To drain water from gear- box: Turn Counterclockwise to open, Clockwise to close. Drain daily to prevent corrosion or damage due to freezing temperatures.

3-2D. HOOD LATCH: Two latches, located on the front frame of the machine secure the ENGINE HOOD (6E) in the lowered position. Rotate each latch 180 degrees, Counter-Clockwise, and the ENGINE HOOD (6E) can be lifted. For European CE models, the latch is a slotted design, and a tool, such as a screw driver must be used to open the latch.

3-2E. FLANGE COVER: Guards against FLANGE con-

tact during operation. Always keep in place!

3-2F. BELT PROTECTOR SHIELD: Keep in place.

3-2G. BLADESHAFT TUBE ASSY: Sealed unit contains bladeshaft, bearings and shaft seals.

3-2H. TIEDOWN LUGS: Used to tie the saw down while transporting by vehicle. Not to be used to lift the saw.

3-2I. ENGINE OIL DRAIN VALVE: Drains engine oil without use of tools.

3-2J. BELT TENSIONING BOLTS:

3-2K. HORIZONTAL CLAMPING BOLTS:

3-2L. BLADE SHAFT PULLEY:

47