IBM 8260 manual Local Management System LMS, SET Port slot.port Network ethernetnisolated

command to assign ports 1 thru 6 to the desired Ethernet segments on the ShuntBus or Enhanced TriChannel.

SET PORT {slot.port} NETWORK {ethernet_nisolated}

Note that ports 7 and 8 are not assigned to any segment on the backplane; therefore, the above command is not required for these ports.

11.6 Local Management System (LMS)

When you connect to the Interconnect module via an ASCII terminal or Telnet session, you can have one of the following two types of sessions:

1. Write session

In this type of session you can alter configuration parameters and view statistics related to the Multiprotocol Interconnect module.

2. Read session

In this type of session you can view the configuration parameters and statistics related to the Multiprotocol Interconnect module.

Up to a maximum of four users can access LMS. One of these can be through the local or modem connected console and the others will be via Telnet sessions. Only one user can have write access at a time, which allows that user to modify the configuration of the module.

Once you connect to the LMS, the initial menu of the LMS as shown in

Figure 138 is displayed.

￿				￿
	6706I-E	Module:
			BladeRunner
		Time:	12:42 5 Jan 95

Configuration Menu

Status Menu

Enable Write Access

Help

Close Connection

	Enter the Config Environment
￿	￿

Figure 138. LMS Initial Panel

The following is a brief description of each selectable option on the initial LMS menu:

Chapter 11. 8260 Multiprotocol Interconnect Module 247