IBM 8260 manual This panel allows you to specify the following options, ∙ Commands, ∙ Ring Speed

￿							￿
	Config *	Physical Port Protocol Parameters
				Module: BladeRunner
	Phy. Port: 7	PHYSICAL PORT		Time:	15:56	5 Jan 95
	Link Protocol:	tokenRing
	Commands:	noOp	Ring Speed:			fourMegabits
	Act Mon Part:	false	Funct MAC Addr Mask:			C00000000000

	Search Port	Prev	Port	Next Port	Exit
		Return to	the previous screen
￿						￿

Figure 148. LMS Physical Port Protocol Configuration Panel

This panel allows you to specify the following options:

∙Commands

This entry allows you to configure the operational status of the token-ring port. The following options are available:

−Open: tells the adapter to enter the ring.

−Close: tells the adapter to remove itself from the ring.

−Reset: causes an immediate reset of the token-ring port.

−Noop: has no effect; it simply indicates that an open operation has not been requested.

∙Ring Speed

This parameter allows you the set the speed at which the token-ring port will operate.

∙Act Mon Par

This parameter allows you to specify if the station is to participate in the active monitor selection process. The choices for this parameter are:

−True

−False

∙Funct MAC Addr Mask

This parameter allows you to specify the bit mask that is applied to all functional addresses for which this port accepts frames.

Chapter 11. 8260 Multiprotocol Interconnect Module 259