−Warmstart: All the configuration settings are read from the FLASH memory, resulting in the restoration of the last saved configuration information. Note that all the statistics tables will be cleared during to a Warmstart.
The Menu Bar options of the Systems Parameters screen allow you to perform the following:
∙Reset Unit
This enables you to initiate an immediate reset of the Interconnect module. When you choose this option, you will be prompted to enter Reset or Cancel to proceed.
∙Change Password
This allows you to change the module′s password for write access. The length of the password can be up to 64 characters and you will be prompted to enter the password twice.
∙Exit
Allows you to return to the previous (Configuration Menu) screen.
An example of the System Parameters panel is shown in Figure 142.
|
|
|
|
| ||
Config * |
| System Parameters |
|
| ||
|
| Module: BladeRunner | ||||
| System |
|
| Time: | 14:29 5 Jan 95 | |
| Name: | BladeRunner |
|
|
| |
| Location: | ITSO Lab, Raleigh |
|
|
| |
| Contact: | Mohammad | Shabani X2339 |
|
|
|
| Station Time: | 14:29 5 | Jan 95 |
|
|
|
| Next Reset: | warmStart |
|
|
|
|
| Reset Module | Change Password | Exit | |
|
| Return to the previous screen |
|
|
|
|
|
Figure 142. LMS System Parameters Panel
2. Trap Destination Table
As shown in Figure 143 on page 254, this panel allows you to specify the SNMP managers to which the Traps are sent.
There can be up to a maximum of eight entries specified in this table and each entry contains the following parameters identifying an SNMP manager and its authority:
∙
∙
IP Address
Community Name
Chapter 11. 8260 Multiprotocol Interconnect Module 253